Drip Emitters

Precision Drippers

With the punch tool, these drippers can be placed exactly where you need along the supply pipe to suit your particular set up and plant spacings. Each dripper is pressure compensated so that water will be released uniformly from each outlet once a pressure of 1 Bar is achieved. Compatible with 16mm and 20mm supply pipe. 20mm is most suitable to ensure adequate volume of water, however, 16mm can be used when only a small amount of drippers are required. Use a filter if using well water.

Spider Assemblies

Microtubing/Spider assemblies with stakes (sold separately) can be pushed onto the drippers to bring water to a precise location. These are available in 1, 2 and 4 way configurations. The correct volume dripper needs to be used for the corresponding microtube assembly:

• 2L/hour (Blue) - Use alone or with single microtube.
• 4L/hour (Black) - For 2 way microtubing.
• 8L/hour (Red) - For 4 way microtubing.

Features:

• Made from high-grade acid recent material to ensure superior weathering characteristics and protection against chemical degradation.
• The unique emitter design and pressure compensating diaphragm allows:
  • Self-flushing during operation and shut-down to facilitate cleaning.
  • The emitter to close upon shut down, thus inhibiting back siphoning and reducing the risk of emitter clogging.
• The semi-circle inlet filters and large turbulent flow path resist clogging by preventing large debris from entering the emitter, and by allowing smaller particles to exit the flow path during the self-flushing cycle.
• Very uniform flow rates across a range of pressure (.55 to 4.1 Bar) making the emitters ideal for use across a variable topography.